No homeowner wants to face a water heater problem. It’s a plumbing problem that most would go out of their way to avoid if they could. Since your home’s water heater is most likely the most expensive component of your indoor plumbing system, problems can be disheartening.
However, there are a couple of problems that are easy to figure out, and if you know how to spot them this could help you out significantly. While we are always here to assist with any repair or replacement needs, we’ve provided the information below about how you can handle two of the most common water heater problems.
If you’ve noticed that your water is either too hot or not getting hot enough, then fixing the problem could be as simple as adjusting your water heater’s thermostat. The temperature for your home’s hot water should ideally be set between 120 and 140 degrees. If there’s no hot water coming from the tank at all despite your settings, then the issue could be a broken thermocouple. Replacing the correct component should restore your hot water supply immediately.
Have you noticed your hot water tank banging, creaking, knocking, or whining? This is most likely indicative of sediment building up inside the tank. When the sediment comes into contact with your tank’s heating element, it makes a lot of noise. This is because the heating element is burning the sediment away. You can try flushing the tank, as this is the best way to correct this problem. If you do but are still hearing excessive noise, then the heating element may be burning out completely. If this is the case, you’ll need to have this part replaced.
For water heater repair in Waukee, IA, contact Golden Rule today!